MirBSD manpage: cardbus(4), cbb(4)

CARDBUS(4)                 BSD Programmer's Manual                  CARDBUS(4)

NAME

     cardbus, cbb - introduction to CardBus support

SYNOPSIS

     cbb*      at pci? dev? function ?
     cardslot* at cbb? flags 0x0000
     cardbus*  at cardslot?
     pcmcia*   at cardslot?

DESCRIPTION

     OpenBSD provides machine-independent bus support and drivers for CardBus
     devices.

     The flags are used with cardslot definition. The lowest order (rightmost)
     bit of flags defines the PC Card attach sequence at boot-time. When the
     bit is set, a PC Card in the slot is probed and attached immediately.
     However, the PC Card is probed after the kernel thread wakes up. If a PC
     Card is used as a boot device (e.g., CF card or network card), this bit
     should be set to 1.

SUPPORTED DEVICES

     OpenBSD includes the following machine-independent CardBus drivers, sort-
     ed by function and driver name:

Network interfaces

        dc(4)
             Intel 21143 and Xircom X3201-based Ethernet interfaces.
        fxp(4)
             Intel PRO/100 CardBus II Ethernet interfaces.
        rl(4)
             Realtek 8129/8139-based Ethernet interfaces.
        xl(4)
             3Com 3c575 and 3c656-based Ethernet interfaces.

SEE ALSO

     intro(4), pci(4), pcibios(4), pcmcia(4)

HISTORY

     The cardbus driver first appeared in NetBSD 1.5. OpenBSD support was ad-
     ded in OpenBSD 2.7.

MirBSD #10-current            November 14, 1999                              1